D-Link DXS-3600 Series Cli Reference Manual page 313

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
This command is used to copy debug information to the destination filename.
debug copy SOURCE-URL DESTINATION-URL
debug copy SOURCE-URL {tftp: //LOCATION/DESTINATION-URL | ftp: //USER-
NAME:PASSWORD@LOCATION:TCP-PORT/DESTINATION-URL | rcp: //USER-
NAME@LOCATION/DESTINATION-URL} [vrf VRF-NAME]
Parameters
SOURCE-URL
LOCATION
USER-NAME
PASSWORD
VRF-NAME
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
None.
Example
This example shows how to copy debug buffer information to a TFTP server (10.90.90.99).
Switch# debug copy buffer tftp: //10.90.90.99/abc.txt
Address of remote host [10.90.90.99]?
Destination filename [abc.txt]?
Accessing tftp://10.90.90.99/abc.txt...
Transmission starts...
Finished network upload(65739) bytes.
Switch#
18-5 debug clear buffer
This command is used to clear the debug buffer.
debug clear buffer
Specifies the source URL for the source file to be copied. It must be
one of the following keywords.
buffer: Specifies to copy the debug buffer information.
error-log: Specifies to copy the error log information.
tech-support: Specifies to copy the technical support information.
Specifies the IPv4 or IPv6 address of the TFTP/FTP/RCP server.
Specifies the user name on the FTP/RCP server.
Specifies the password for the user.
Specifies the name of the VRF instance which the TFTP/FTP/RCP
server belongs to.
308