D-Link DXS-3600 Series Cli Reference Manual page 287

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
pdu-priority COS-VALUE
Default
By default, the PDU priority is level 7.
Command Mode
CFM MEP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to define the 802.1p priority that is set in the CCM and the LTM messages
transmitted by the MEP.
Example
This example shows how to define the 802.1p priority that is set in the CCM and the LTM messages
transmitted by the MEP.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# cfm mep mepid 1 ma name op1 domain op-domain
Switch(config-cfm-mep)# pdu-priority 2
Switch(config-cfm-mep)#
15-23 sender-id (cfm md configuration)
This command is used to configure the default transmission of the sender ID TLV by MPs in a
maintenance domain. To reset the configuration of the transmission of the sender ID TLV to the default
setting, use the no command.
sender-id {none | chassis | manage | chassis-manage}
no sender-id
Parameters
none
chassis
manage
chassis-manage
Default
None.
Command Mode
Specifies that the 802.1p priority is set in the CCM and the LTM
messages transmitted by the MEP. The range of the value is from 0 to
7.
Specifies not to transmit the sender ID TLV.
Specifies to transmit the sender ID TLV with the chassis ID
information.
Specifies to transmit the sender ID TLV with the managed address
information.
Specifies to transmit the sender ID TLV with the chassis ID information
and the managed address information.
282