Debug Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

18. Debug Commands

18-1 debug enable
This command is used to enable the debug message output option. To disable the debug message
output option, use the no form of this command.
debug enable
no debug enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to enable the debug message output option.
Example
This example shows how to enable and then disable the debug message output option.
Switch(config)# debug enable
Switch(config)# no debug enable
Switch(config)#
18-2 debug output
This command is used to specify the output for the debug messages of individual modules.
debug output {module <MODULE-LIST> | all} {buffer | console}
no debug output {module <MODULE-LIST> | all}
Parameters
<MODULE-LIST>
all
buffer
console
Specifies the module list to output the debug messages. Leave a
space between modules.
Specifies to output the debug messages of all modules to the specified
destination.
Specifies to output the debug message to the debug buffer.
Specifies to output the debug messages to the local console.
306