Command Logging Commands - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide

14. Command Logging Commands

14-1 command logging enable
This command is used to enable the command logging function. Use the no form of this command to
disable the command logging function.
command logging enable
no command logging enable
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 15.
Usage Guideline
The command logging function is used to log the commands that have successfully been configured to
the switch via the command line interface. The requirement is to log the command itself, along with
information about the user account that entered the command into the system log. Commands that do not
cause a change in the switch configuration or operation (such as show) will not be logged. Information
about saving or viewing the system log is described in the sys-log functional specification.
Note: When the switch is under the BAT process (booting procedure, execute downloaded configuration
files, etc...), all configuration commands will not be logged.
Example
This example shows how to enable the command logging function.
Switch# configure terminal
Switch(config)# command logging enable
Switch(config)#
264