D-Link DXS-3600 Series Cli Reference Manual page 271

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Switch(config-cfm-mep)# ais level 5
Switch(config-cfm-mep)#
15-2 alarm-time
This command is used to define the time period to control when a fault alarm will be sent since a defect is
detected and the time period to control when a fault alarm will be reset since all defects are removed. Use
the no form of the command to reset to the default setting.
alarm-time {delay CENTISECOND | reset CENTISECOND}
no alarm-time {delay | reset}
Parameters
delay CENTISECOND
reset CENTISECOND
Default
The default value of the MEP alarm delay time is 250.
The default value of the MEP alarm reset time is 1000.
Command Mode
CFM MEP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command defines the time period to control when a fault alarm will be sent since a defect is detected.
That's to say, if a MEP detects a defect, the corresponding fault alarm will be sent only when the defect is
present for the delay time. This command also defines the time when a fault alarm will be reset since all
defects are removed.
Example
This example shows how to configure an MEP alarm time. Assign the alarm time of the MEP to 250.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# cfm mep mepid 1 ma name op1 domain op-domain
Switch(config-cfm-mep)# alarm-time delay 250
Switch(config-cfm-mep)#
This example shows how to configure an MEP alarm reset time. Assign the alarm reset time of the MEP
to 1000.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# cfm mep mepid 1 ma name op1 domain op-domain
Specifies the time period to control when a fault alarm will be sent
since a defect is detected. The unit is centiseconds. The range is from
250 to 1000.
Specifies the time period to control when a fault alarm will be reset
since the all defects are removed. The unit is centiseconds. The range
is from 250 to 1000.
266