DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
16. CPU Access Control List (ACL) Commands
16-1 soft-acl filter-map
This command is used to create or modify a software ACL filter map. This command will enter into the
software ACL filter map configuration mode. Use the no command to remove a software ACL filter map.
soft-acl filter-map NAME
no soft-acl filter-map NAME
Parameters
NAME
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enter into the software ACL filter map configuration mode, to associate some pre-
defined ACL access list(s) to filter packets received at CPU. Multiple software ACL filter maps can be
configured.
Example
This example shows how to create a software ACL filter map named "cpu_filter".
Switch# configure terminal
Switch(config)# soft-acl filter-map cpu_filter
Switch(config-soft-acl)#
16-2 match access-group
This command is used to associate an access list to the software ACL filter map. Use the no command to
remove an association.
SEQUENCE-NUMBER match mac access-group NAME
SEQUENCE-NUMBER match ip access-group NAME
SEQUENCE-NUMBER match ipv6 access-group NAME
SEQUENCE-NUMBER match expert access-group NAME
no match {mac | ip | ipv6 | expert} access-group
Parameters
Specifies the name of the software ACL filter map to be configured.
The name can be up to 32 characters.
299