Cfm Domain - D-Link DXS-3600 Series Cli Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Default
By default, this value is 10 seconds.
Command Mode
CFM MA Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure the CCM interval for an MA. An MEP will transmit a CCM packet
periodically across the MA. The CCM interval indicates the interval at which CCMs are sent by a MEP in a
MA.
Example
This example shows how to configure the CCM interval for an MA.
Switch# configure terminal
Switch(config)# cfm domain op-domain level 2
Switch(config-cfm-md)# cfm ma name op1 vlan 2
Switch(config-cfm-ma)# ccm interval 10sec
Switch(config-cfm-ma)#

15-5 cfm domain

This command is used to define an MD. To delete an MD, use the no command.
cfm domain DOMAIN-NAME level LEVEL
no cfm domain DOMAIN-NAME
Parameters
domain DOMAIN-NAME
level LEVEL
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
1sec: One second.
10sec: Ten seconds. This is the default value.
1min: One minute.
10min: Ten minutes.
(Optional) Specifies the MD name as the identifier. It is a string type of
maximum length 22. The name does not allow embedded spaces.
Specifies the MD level. The range is from 0 to 7.
268