D-Link DXS-3600 Series Cli Reference Manual page 282

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
15-16 fault-alarm
This command is used to control the types of fault alarms sent by the MEP. To reset to the default setting,
use no command.
fault-alarm {none | all | mac-status | remote-ccm | error-ccm | xcon-ccm}
no fault-alarm
Parameters
none
all
mac-status
remote-ccm
error-ccm
xcon-ccm
Default
By default, this option is none.
Command Mode
CFM MEP Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to control the types of fault alarms sent by the MEP.
Example
This example shows how to configure the MEP to send all types of fault alarms.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# cfm mep mepid 1 ma name op1 domain op-domain
Switch(config-cfm-mep)# fault-alarm all
Switch(config-cfm-mep)#
15-17 lck
This command is used to configure the parameters of the LCK function. To disable the CFM LCK function,
use the no command.
lck [period PERIOD] [level LEVEL]
no lck [period | level]
Specifies that no fault alarm will be sent.
Specifies that all types of fault alarms will be sent.
Specifies that only the fault alarms whose priority is equal to or higher
than "Some Remote MEP MAC Status Errors" will be sent.
Specifies that only the fault alarms whose priority is equal to or higher
than "Some Remote MEPs Down" will be sent.
Specifies that only the fault alarms whose priority is equal to or higher
than "Error CCM Received" will be sent.
Specifies that only the fault alarms whose priority is equal to or higher
than "Cross-connect CCM Received" will be sent.
277