D-Link DXS-3600 Series Cli Reference Manual page 278

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Request timed out.
CFM loopback statistics for 00-01-02-03-04-05:
Packets: Sent=4, Received=0, Lost=4(100% loss).
Switch# cfm loopback test remote-mepid 2 mepid 1 ma name op-ma1 domain op-domain1
Reply from 00-01-02-03-04-05: bytes=0 time=10ms
Reply from 00-01-02-03-04-05: bytes=0 time=10ms
Reply from 00-01-02-03-04-05: bytes=0 time=10ms
Reply from 00-01-02-03-04-05: bytes=0 time=10ms
CFM loopback statistics for 00-01-02-03-04-05:
Packets: Sent=4, Received=4, Lost=0(0% loss).
Switch#
15-11 cfm ma
This command is used to define a maintenance association and enter the CFM MA Configuration Mode.
To delete a maintenance association, use the no command.
cfm ma name MA-NAME [vlan VLAN-ID]
no cfm ma name MA-NAME
Parameters
name MA-NAME
vlan VLAN-ID
Default
None.
Command Mode
CFM MD Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to define or delete a maintenance association and enter the CFM MA
Configuration Mode. Each maintenance association in a maintenance domain must have a unique
maintenance association name. The maintenance associations configured in different maintenance
domains may have the same maintenance association identifier. When the maintenance association is
deleted, the configuration based on it is also deleted.
Example
This example shows how to create a maintenance association called "op1" which is assigned to the
maintenance domain named op-domain.
Switch# configure terminal
Switch(config)# cfm domain op-domain level 2
Switch(config-cfm-md)# cfm ma name op1 vlan 2
Switch(config-cfm-ma)#
Specifies the MA with a name as the identifier.
Specifies the primary VLAN ID of the maintenance association.
273