Show Lacp Interfaces - Juniper ACX1000 Configuration Manual

show lacp interfaces

Syntax
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Table 166: show lacp interfaces Output Fields
Field Name Field Description
Aggregated interface Aggregated interface value.
Copyright © 2017, Juniper Networks, Inc.
show lacp interfaces
<interface-name>
extensive
Command introduced in Junos OS Release 7.6.
statement introduced in Junos OS Release 16.1R1
extensive
Display Link Aggregation Control Protocol (LACP) information about the specified
aggregated Ethernet, Fast Ethernet, or Gigabit Ethernet interface.
—Display LACP information for all interfaces.
none
—(Optional) Display LACP information for the specified interface:
interface-name
Aggregated Ethernet—
Fast Ethernet—
fe-fpc/pic/port
Gigabit Ethernet—
ge-fpc/pic/port
10 Gigabit Ethernet—
extensive—Display LACP information for the interface in detail.
NOTE: The
show lacp interfaces
if your system is not configured in either active or passive LACP mode:
"Warning: lacp subsystem not running – not needed by configuration"
view
show lacp interfaces (Aggregated Ethernet) on page 2724
show lacp interfaces (Gigabit Ethernet) on page 2724
show lacp interfaces (10 Gigabit Ethernet) on page 2725
Table 166 on page 2721 lists the output fields for the
fields are listed in the approximate order in which they appear.
aenumber
xe-fpc/pic/port
command returns the following error message
show lacp interfaces
Chapter 42: Operational Commands
command. Output
2721