Juniper ACX1000 Configuration Manual page 2961

Table 199: show ppp interface Output Fields (continued)
Field Name Field Description
IPCP Internet Protocol Control Protocol (IPCP) information.
State
Ack-rcvd
Ack-sent
Configure-Ack has not yet been received.
Closed
Opened
Req-sent
State
Ack-rcvd
Ack-sent
Configure-Ack has not yet been received.
Closed
Closing
received.
Opened
sent and received.
Req-sent
has been sent but a Configure-Ack has not yet been received.
Starting
(Down).
Stopped
or after sending a Terminate-Ack.
Stopping
received.
Last started
Last completed
Negotiated options:
compression protocol
compression is not enabled.
local address
octets are set to zero, the peer provides the IP address.
primary DNS server
DNS server to be used on the local end of the link.
primary WINS server
WINS server to be used on the local end of the link.
remote address
secondary DNS server
secondary DNS server to be used on the local end of the link.
secondary WINS server
secondary WINS server to be used on the local end of the link.
Negotiation mode
IPCP:
Copyright © 2017, Juniper Networks, Inc.
—(All platforms except M120 and M320 routers) One of the following values:
—A Configure-Request has been sent and a Configure-Ack has been received.
—A Configure-Request and a Configure-Ack have both been sent, but a
—Link is not available for traffic.
—Link is administratively available for traffic.
—An attempt has been made to configure the connection.
—(M120 and M320 routers) One of the following values:
—A Configure-Request has been sent and a Configure-Ack has been received.
—A Configure-Request and a Configure-Ack have both been sent, but a
—Link is available (up), but no Open has occurred.
—A Terminate-Request has been sent but a Terminate-Ack has not yet been
—Link is administratively available for traffic. A Configure-Ack has been both
—An attempt has been made to configure the connection. A Configure-Request
—An administrative Open has been initiated, but the lower layer is still unavailable
—The system is waiting for a Down event after the This-Layer-Finished action,
—A Terminate-Request has been sent but a Terminate-Ack has not yet been
—IPCP state start time.
—IPCP state authentication completion time.
—Negotiate the use of a specific compression protocol. By default,
—Desired local address of the sender of a Configure-Request. If all four
—Negotiate with the remote peer to select the address of the primary
—Negotiate with the remote peer to select the address of the primary
—IP address of the remote end of the link in dotted quad notation.
—Negotiate with the remote peer to select the address of the
—Negotiate with the remote peer to select the address of the
—PPP Network Control Protocol (NCP) negotiation mode configured for
Active or Passive
Chapter 42: Operational Commands
Level of
Output
extensive
2903