Juniper ACX1000 Configuration Manual page 2729

Table 155: Aggregated Ethernet show interfaces Output Fields (continued)
Field Name Field Description
LACP Statistics LACP statistics for each aggregated interface.
LACP Rx
LACP Tx
Unknown Rx
Illegal Rx
NOTE:
expiry (30 secs).
Protocol family configured on the logical interface. Possible values are described
protocol-family
in the "Protocol Field" section under Common Output Fields Description.
Protocol family configured on the logical interface. Possible values are described
Protocol
in the "Protocol Field" section under Common Output Fields Description.
Maximum transmission unit size on the logical interface.
MTU
Maximum number of MPLS labels configured for the MPLS protocol family on
Maximum labels
the logical interface.
Generation Unique number for use by Juniper Networks technical support only.
Route Table Routing table in which the logical interface address is located. For example,
refers to the routing table inet.0.
Information about protocol family flags. Possible values are described in the
Flags
"Family Flags Field" section under Common Output Fields Description.
Number of MAC address validation failures for packets and bytes. This field is
Mac-Validate
displayed when MAC address validation is enabled for the logical interface.
Failures
Information about address flags. Possible values are described in the "Addresses
Addresses, Flags
Flags" section under Common Output Fields Description.
Destination IP address of the remote side of the connection.
Local IP address of the logical interface.
Broadcast address of the logical interface.
Broadcast
Unique number for use by Juniper Networks technical support only.
Generation
Sample Output
show interfaces (Aggregated Ethernet)
Copyright © 2017, Juniper Networks, Inc.
—LACP received counter that increments for each normal hello.
—Number of LACP transmit packet errors logged.
—Number of unrecognized packet errors logged.
—Number of invalid packets received.
For and , Packet count is updated only on snmp timer
LACP Rx LACP Tx
user@host> show interfaces ae0
Chapter 42: Operational Commands
Level of Output
none
detail extensive
brief
none
detail extensive
none
detail extensive
none
detail extensive
detail extensive
0 detail extensive
none
detail extensive
none
detail extensive
none
detail extensive
detail extensive none
detail extensive none
none
detail extensive
detail extensive
2671