Juniper ACX1000 Configuration Manual page 3176

ACX Series Universal Access Router Configuration Guide
Table 226: show route table Output Fields (continued)
Field Name Field Description
[protocol, preference] Protocol from which the route was learned and the preference value for the route.
In every routing metric except for the BGP
use common comparison routines, Junos OS stores the 1's complement of the
Preference2
If the
has a higher
Level (IS-IS only). In IS-IS, a single AS can be divided into smaller groups called areas. Routing between
areas is organized hierarchically, allowing a domain to be administratively divided into smaller areas.
This organization is accomplished by configuring Level 1 and Level 2 intermediate systems. Level 1
systems route within an area. When the destination is outside an area, they route toward a Level 2
system. Level 2 intermediate systems route between areas and toward other ASs.
Route Distinguisher IP subnet augmented with a 64-bit prefix.
PMSI Provider multicast service interface (MVPN routing table).
Next-hop type Type of next hop. For a description of possible values for this field, see
Next-hop reference Number of references made to the next hop.
count
Flood nexthop Indicates that the number of flood next-hop branches exceeded the system limit of 32 branches, and
branches exceed only a subset of the flood next-hop branches were installed in the kernel.
maximum message
Source IP address of the route source.
Next hop Network layer address of the directly reachable neighboring system.
via Interface used to reach the next hop. If there is more than one interface available to the next hop, the
name of the interface that is actually used is followed by the word
the following information:
Label-switched-path Name of the LSP used to reach the next hop.
lsp-path-name
3118
—A plus sign indicates the active route, which is the route installed from the routing table into the
+
forwarding table.
—A hyphen indicates the last active route.
-
—An asterisk indicates that the route is both the active and the last active route. An asterisk before
*
a to line indicates the best subpath to the route.
field. For example, if the
value for Route 2 is 155, the
LocalPref
value and a lower
LocalPref
Weight—Value used to distinguish primary, secondary, and fast reroute backup routes. Weight
information is available when MPLS label-switched path (LSP) link protection, node-link protection,
or fast reroute is enabled, or when the standby state is enabled for secondary paths. A lower weight
value is preferred. Among routes with the same weight value, load balancing is possible.
Balance—Balance coefficient indicating how traffic of unequal cost is distributed among next hops
when a routing device is performing unequal-cost load balancing. This information is available
when you enable BGP multipath load balancing.
attribute, a lesser value is preferred. In order to
LocalPref
LocalPref value for Route 1 is 100, the
value is -156. Route 2 is preferred because it
Preference2
value.
Preference2
Selected
Copyright © 2017, Juniper Networks, Inc.
LocalPref value in the
Preference2 value is -101.
Table 217 on page 3006.
. This field can also contain