Juniper ACX1000 Configuration Manual page 2952

ACX Series Universal Access Router Configuration Guide
Sample Output
show poe controller (EX3200 Switch)
show poe controller (EX8200 Switch)
2894
Table 197: show poe controller Output Fields (continued)
Field Name Field Description
Total amount of power being consumed by the PoE ports at the time the
Power consumption
command is executed. This value, which represents actual power consumption,
cannot exceed the value for
Guard Band Amount of power that has been placed in reserve for power demand spikes and
that cannot be allocated to a PoE interface.
Power management mode:
Management
NOTE:
Status Status of the PoE controller:
AF_ENHANCE
PoE port is 18.6 W in static mode (15.4 W in class mode).
DEVICE FAIL
controller is not initialized because of a hardware failure.
DOWNLOAD_INIT
AF_MODE
per PoE port is 15.4 W.
AT/AF COMBO
802.3at (PoE+) ports. The maximum power per port is 30 W for IEEE 802.3at
(PoE+) ports and 15.4 W for the IEEE 802.3af ports.
AT_MODE
per PoE port is 30 W.
SW_DOWNLOAD (n%)
Lldp Priority Link Layer Discovery Protocol (LLDP) priority operating state. The state can be
Enabled
LLDP priority enables the PoE controller to assign interfaces the power priority
provided by the connected powered device by using LLDP power negotiation
rather than the power priority configured on the switch interface.
user@switch> show poe controller
Controller Maximum Power
index power consumption
0 130.00W 81.20W
user@switch> show poe controller
Controller Maximum Power
index power consumption
0 792.00W 603.50W
4 915.00W 781.00W
7 915.00W 0.00W
Maximum power
or
class static
The mode high-power is available on only ACX2000 routers.
—Controller supports enhanced PoE. The maximum power per
—Software download to the controller has failed or the PoE
—Software download to the controller is in the initial phase.
—Controller supports standard IEEE 802.3af. The maximum power
—Controller supports a mix of standard IEEE 802.3af and IEEE
—Controller supports IEEE 802.3at (PoE+). The maximum power
—Software download to the controller is in progress.
or Disabled .
Guard Management
band
10W Static
Guard Management
band
0W Class
0W Class
0W Class
.
or .
high-power
Status Lldp
Priority
AF_ENHANCE Disabled
Status Lldp
Priority
AT/AF COMBO Disabled
AT/AF COMBO Disabled
AT/AF COMBO Disabled
Copyright © 2017, Juniper Networks, Inc.