Juniper ACX1000 Configuration Manual page 2851

Table 180: show oam ethernet connectivity-fault-management mep-database Output
Fields (continued)
Field Name Field Description
LSR/LER forwarding the CCM Frame into a bypass tunnel is set.
FRR Flag
Its value can be
Maintenance association end point (MEP) identifier.
MEP identifier
MEP direction configured.
Direction
MAC address configured for the MEP.
MAC address
Whether automatic discovery is enabled or disabled.
Auto-discovery
Priority used for CCMs and linktrace messages transmitted by the MEP.
Priority
Interface identifier.
Interface name
Local interface status.
Interface status
Local link status.
Link status
Whether the remote MEP is not receiving CCMs.
Remote MEP not
receiving CCM
Whether erroneous CCMs have been received.
Erroneous CCM received
Whether cross-connect CCMs have been received.
Cross-connect CCM
received
Whether the remote defect indication (RDI) bit is set in messages that have been received. The
RDI sent by some MEP
absence of the RDI bit in a CCM indicates that the transmitting MEP is receiving CCMs from all
configured MEPs.
CCMs sent Number of CCMs transmitted.
CCMs received out of Number of CCMs received out of sequence.
sequence
LBMs sent Number of loopback messages (LBMs) sent.
Valid in-order LBRs Number of loopback response messages (LBRs) received that were valid messages and in sequence.
received
1DMs sent If the MEP is an initiator for a one-way ETH-DM session: Number of one-way delay measurement
(1DM) PDU frames sent to the peer MEP in this session.
For all other cases, this field displays
Copyright © 2017, Juniper Networks, Inc.
or .
yes no
0 .
Chapter 42: Operational Commands
2793