Juniper ACX1000 Configuration Manual page 3175

Table 226: show route table Output Fields (continued)
Field Name Field Description
number routes Number of routes in the routing table and total number of routes in the following states:
route-destination Route destination (for example:10.0.0.1/24). The
(entry, announced) and the
the route destination is presented in another format, such as:
label stacking ( Next-to-the-last-hop routing device for MPLS only) Depth of the MPLS label stack, where the
label-popping operation is needed to remove one or more labels from the top of the stack. A pair of
routes is displayed, because the pop operation is performed only when the stack depth is two or more
labels.
Copyright © 2017, Juniper Networks, Inc.
(routes that are active)
active
(routes that are in the pending state before being declared inactive)
holddown
hidden (routes that are not used because of a routing policy)
value is the number of routes being announced for this destination. Sometimes
announced
(for example, 80001).
MPLS-label
interface-name (for example, ge-1/0/2).
neighbor-address:control-word-status:encapsulation type:vc-id:source
10.1.1.195:NoCtrlWord:1:1:Local/96).
—Address of the neighbor.
neighbor-address
control-word-status —Whether the use of the control word has been negotiated for this virtual
circuit: or
NoCtrlWord CtrlWord
encapsulation type —Type of encapsulation, represented by a number: (1) Frame Relay DLCI, (2)
ATM AAL5 VCC transport, (3) ATM transparent cell transport, (4) Ethernet, (5) VLAN Ethernet,
(6) HDLC, (7) PPP, (8) ATM VCC cell transport, (10) ATM VPC cell transport.
—Virtual circuit identifier.
vc-id
—Source of the advertisement:
source
inclusive multicast Ethernet tag route
3:100.100.100.10:100::0::10::100.100.100.10/384):
route distinguisher—(8 octets) Route distinguisher (RD) must be the RD of the EVPN instance
(EVI) that is advertising the NLRI.
Ethernet tag ID—(4 octets) Identifier of the Ethernet tag. Can set to 0 or to a valid Ethernet tag
value.
IP address length—(1 octet) Length of IP address in bits.
originating router's IP address—(4 or 16 octets) Must set to the provider edge (PE) device's IP
address. This address should be common for all EVIs on the PE device, and may be the PE device's
loopback address.
S=0 route indicates that a packet with an incoming label stack depth of 2 or more exits this routing
device with one fewer label (the label-popping operation is performed).
If there is no S= information, the route is a normal MPLS route, which has a stack depth of 1 (the
label-popping operation is not performed).
value is the number of routes for this destination,
entry
.
or .
Local Remote
—Type of route destination represented by (for example,
Chapter 42: Operational Commands
(Layer 2 circuit only; for example,
3117