Juniper ACX1000 Configuration Manual page 2853

Table 180: show oam ethernet connectivity-fault-management mep-database Output
Fields (continued)
Field Name Field Description
Sequence number of the next linktrace message request to be transmitted.
Sequence number of
next LTM request
If the interface is attached to an initiator MEP for a ETH-LM session: Number of loss measurement
LMM sent
message (LMM) PDU frames sent to the peer MEP in this session.
If the interface is attached to an initiator MEP for a ETH-LM session: Number of valid loss measurement
Valid LMM received
request packets received.
Invalid LMM received If the interface is attached to an initiator MEP for a ETH LM session: Number of invalid loss
measurement request packets received.
If the interface is attached to a responder MEP for a ETH-LM session: Number of loss measurement
LMR sent
reply (LMR) frames sent.
Valid LMR received If the interface is attached to an initiator MEP for a ETH LM session: Number of valid LMR frames
received.
If the interface is attached to an initiator MEP for a ETH-LM session: Number of invalid LMR frames
Invalid LMR received
received.
If the interface is attached to an initiator MEP for a ETH-SLM session: Number of synthetic loss
SLM sent
measurement (SLM) request packets transmitted from the source MEP to the remote or destination
MEP in this session.
If the interface is attached to a responder MEP for a ETH-SLM session: Number of valid SLM PDUs
Valid SLM received
transmitted from the source MEP to the remote or destination MEP.
If the interface is attached to a responder MEP for a ETH-SLM session: Number of invalid SLM PDUs
Invalid SLM received
transmitted from the source MEP to the remote or destination MEP.
If the interface is attached to a responder MEP for a ETH-SLM session: Number detail extensive of
SLR sent
synthetic loss reply (SLR) frames sent.
If the interface is attached to an initiator MEP for a ETH-SLM session: Number of valid SLR PDUs that
Valid SLR received
the source MEP received from the remote or destination MEP.
Invalid SLR received If the interface is attached to an initiator MEP for a ETH-SLM session: Number of invalid SLR PDUs
that the source MEP received from the remote or destination MEP.
MEP identifier of the remote MEP.
Remote MEP identifier
State of the remote MEP:
State (remote MEP)
MAC address of the remote MEP.
MAC address
Whether the remote MEP MAC address was learned using automatic discovery or configured.
Type
Copyright © 2017, Juniper Networks, Inc.
, , , or .
idle start ok failed
Chapter 42: Operational Commands
2795