Juniper ACX1000 Configuration Manual page 3113

show route forwarding-table extensive (RPF)
Copyright © 2017, Juniper Networks, Inc.
Route type: permanent
Route reference: 0
Flags: sent to PFE
Next-hop type: reject
Routing table: inet6 [Index 0]
Internet6:
Destination: default
Route type: permanent
Route reference: 0
Flags: sent to PFE
Next-hop type: reject
Destination: ff00::/8
Route type: permanent
Route reference: 0
Flags: sent to PFE
Next-hop type: multicast discard
...
Routing table: private1__.inet6 [Index 1]
Internet6:
Destination: default
Route type: permanent
Route reference: 0
Flags: sent to PFE
Next-hop type: reject
Destination: fe80::2a0:a5ff:fe3d:375/128
Route type: interface
Route reference: 0
Flags: sent to PFE
Nexthop: fe80::2a0:a5ff:fe3d:375
Next-hop type: local
...
The next example is based on the following configuration, which enables an RPF check
on all routes that are learned from this interface, including the interface route:
so-1/1/0 {
unit 0 {
family inet {
rpf-check;
address 192.0.2.2/30;
}
}
}
user@host> show route forwarding-table extensive
Routing table: inet [Index 0]
Internet:
...
...
Destination: 192.0.2.3/32
Chapter 42: Operational Commands
Route interface-index: 0
Index: 38 Reference: 1
Route interface-index: 0
Index: 22 Reference: 1
Route interface-index: 0
Index: 21 Reference: 1
Route interface-index: 0
Index: 54 Reference: 1
Route interface-index: 0
Index: 75 Reference: 1
3055