Juniper ACX1000 Configuration Manual page 3181

Copyright © 2017, Juniper Networks, Inc.
Table 227: Next-hop Types Output Field Values (continued)
Next-Hop Type
Resolve (rslv)
Routed multicast (mcrt)
Router
Table
Unicast (ucst)
Unilist (ulst)
Table 218 on page 3008 describes all possible values for the State output field. A route can
be in more than one state (for example,
Table 228: State Output Field Values
Value
Accounting
Active
Always Compare MED
AS path
Cisco Non-deterministic MED
selection
Clone
Cluster list length
Delete
Ex
Chapter 42: Operational Commands
Description
Resolving next hop.
Regular multicast next hop.
A specific node or set of nodes to which the routing device
forwards packets that match the route prefix.
To qualify as a next-hop type router, the route must meet
the following criteria:
Must not be a direct or local subnet for the routing
device.
Must have a next hop that is directly connected to the
routing device.
Routing table next hop.
Unicast.
List of unicast next hops. A packet sent to this next hop
goes to any next hop in the list.
<Active NoReadvrt Int Ext>
Description
Route needs accounting.
Route is active.
Path with a lower multiple exit discriminator (MED) is
available.
Shorter AS path is available.
Cisco nondeterministic MED is enabled, and a path with a
lower MED is available.
Route is a clone.
Length of cluster list sent by the route reflector.
Route has been deleted.
Exterior route.
).
3123