Juniper ACX1000 Configuration Manual page 3059

Table 216: show route detail Output Fields (continued)
Field Name Field Description
Number of routes in the routing table and total number of routes in the following states:
number routes
Route destination (for example:10.0.0.1/24). The
route-destination
and the
(entry, announced)
the route destination is presented in another format, such as:
Next-to-the-last-hop routing device for MPLS only) Depth of the MPLS label stack, where the
label stacking (
label-popping operation is needed to remove one or more labels from the top of the stack. A pair of
routes is displayed, because the pop operation is performed only when the stack depth is two or more
labels.
Copyright © 2017, Juniper Networks, Inc.
(routes that are active)
active
(routes that are in the pending state before being declared inactive)
holddown
hidden (routes that are not used because of a routing policy)
value is the number of routes being announced for this destination. Sometimes
announced
(for example, 80001).
MPLS-label
interface-name (for example, ge-1/0/2).
neighbor-address:control-word-status:encapsulation type:vc-id:source
10.1.1.195:NoCtrlWord:1:1:Local/96).
—Address of the neighbor.
neighbor-address
control-word-status —Whether the use of the control word has been negotiated for this virtual
circuit: or
NoCtrlWord CtrlWord
encapsulation type —Type of encapsulation, represented by a number: (1) Frame Relay DLCI, (2)
ATM AAL5 VCC transport, (3) ATM transparent cell transport, (4) Ethernet, (5) VLAN Ethernet,
(6) HDLC, (7) PPP, (8) ATM VCC cell transport, (10) ATM VPC cell transport.
—Virtual circuit identifier.
vc-id
—Source of the advertisement:
source
—Source of the advertisement:
source
indicates that a packet with an incoming label stack depth of 2 or more exits this routing
S=0 route
device with one fewer label (the label-popping operation is performed).
If there is no information, the route is a normal MPLS route, which has a stack depth of 1 (the
S=
label-popping operation is not performed).
value is the number of routes for this destination,
entry
.
or .
Local Remote
or .
Local Remote
Chapter 42: Operational Commands
(Layer 2 circuit only; for example,
3001