Juniper ACX1000 Configuration Manual page 3089

Table 221: show route extensive Output Fields (continued)
Field Name Field Description
Indicates the status of a BGP route:
route status
Primary Upstream When multipoint LDP with multicast-only fast reroute (MoFRR) is configured, the primary upstream
path. MoFRR transmits a multicast join message from a receiver toward a source on a primary path,
while also transmitting a secondary multicast join message from the receiver toward the source on
a backup path.
RPF Nexthops When multipoint LDP with MoFRR is configured, the reverse-path forwarding (RPF) next-hop
information. Data packets are received from both the primary path and the secondary paths. The
redundant packets are discarded at topology merge points due to the RPF checks.
Label Multiple MPLS labels are used to control MoFRR stream selection. Each label represents a separate
route, but each references the same interface list check. Only the primary label is forwarded while all
others are dropped. Multiple interfaces can receive packets using the same label.
weight Value used to distinguish MoFRR primary and backup routes. A lower weight value is preferred. Among
routes with the same weight value, load balancing is possible.
VC Label MPLS label assigned to the Layer 2 circuit virtual connection.
MTU Maximum transmission unit (MTU) of the Layer 2 circuit.
VLAN ID VLAN identifier of the Layer 2 circuit.
Cluster list (For route reflected output only) Cluster ID sent by the route reflector.
(For route reflected output only) Address of router that originally sent the route to the route reflector.
Originator ID
Forwarding Equivalent Class (FEC) bound to this route. Applicable only to routes installed by LDP.
Prefixes bound to route
Community path attribute for the route. See the Output Field table in the
Communities
for all possible values for this field.
Layer 2 encapsulation (for example, VPLS).
Layer2-info: encaps
Control flags:
control flags
Maximum transmission unit (MTU) information.
mtu
First label in a block of labels and label block size. A remote PE routing device uses this first label
Label-Base, range
when sending traffic toward the advertising PE routing device.
Copyright © 2017, Juniper Networks, Inc.
—The specified BGP route is imported by the default BGP policy.
Accepted
—The route is imported into a Layer 3 VPN routing instance.
Import
Import-Protect —A remote instance egress that is protected.
Multipath —A BGP multipath active route.
—The route is not active but contributes to the BGP multipath.
MultipathContrib
—An egress route that is protected.
Protect
—A route that is marked stale due to graceful restart.
Stale
or Site Down.
none
Chapter 42: Operational Commands
command
show route detail
3031