Juniper ACX1000 Configuration Manual page 2962

ACX Series Universal Access Router Configuration Guide
Table 199: show ppp interface Output Fields (continued)
Field Name Field Description
IPV6CP Internet Protocol version 6 Control Protocol (IPv6CP) information.
State
Ack-rcvd
Ack-sent
Configure-Ack has not yet been received.
Closed
Opened
Req-sent
State
Ack-rcvd
Ack-sent
Configure-Ack has not yet been received.
Closed
Closing
received.
Opened
sent and received.
Req-sent
has been sent but a Configure-Ack has not yet been received.
Starting
(Down).
Stopped
or after sending a Terminate-Ack.
Stopping
received.
Last started
Last completed
Negotiated options
local interface identifier
all four octets are set to zero, the peer provides the IP address.
remote interface identifier
notation.
Negotiation mode
IPv6CP:
2904
—(All platforms except M120 and M320 routers) One of the following values:
—A Configure-Request has been sent and a Configure-Ack has been received.
—A Configure-Request and a Configure-Ack have both been sent, but a
—Link is not available for traffic.
—Link is administratively available for traffic.
—An attempt has been made to configure the connection.
—(M120 and M320 routers) One of the following values:
—A Configure-Request has been sent and a Configure-Ack has been received.
—A Configure-Request and a Configure-Ack have both been sent, but a
—Link is available (up), but no Open has occurred.
—A Terminate-Request has been sent but a Terminate-Ack has not yet been
—Link is administratively available for traffic. A Configure-Ack has been both
—An attempt has been made to configure the connection. A Configure-Request
—An administrative Open has been initiated, but the lower layer is still unavailable
—The system is waiting for a Down event after the This-Layer-Finished action,
—A Terminate-Request has been sent but a Terminate-Ack has not yet been
—IPV6CP state start time.
—IPV6CP state authentication completion time.
:
—Desired local address of the sender of a Configure-Request. If
—IP address of the remote end of the link in dotted quad
—PPP Network Control Protocol (NCP) negotiation mode configured for
Active or Passive
Level of
Output
extensive
Copyright © 2017, Juniper Networks, Inc.