Show Multicast Snooping Next-Hops - Juniper ACX1000 Configuration Manual

show multicast snooping next-hops

Syntax
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Table 174: show multicast snooping next-hops Output Fields
Field Name Field Description
Protocol family for which multicast snooping next hops are displayed:
Family
Number of cache entries that are using this next hop.
Refcount
Kernel reference count for the next hop.
KRefcount
Interface names associated with each multicast next-hop ID.
Downstream interface
Copyright © 2017, Juniper Networks, Inc.
show multicast snooping next-hops
<brief | detail>
<identifier next-hop-ID>
<inet>
<inet6>
<logical-system logical-system-name>
Command introduced in Junos OS Release 11.2.
Display information about the IP multicast snooping next-hops.
brief | detail—(Optional) Display the specified level of output.
inet—(Optional) Display information for IPv4 multicast next hops only. If a family is not
specified, both IPv4 and IPv6 results will be shown.
inet6—(Optional) Display information for IPv6 multicast next hops only. If a family is not
specified, both IPv4 and IPv6 results will be shown.
logical-system logical-system-name—(Optional) Display information about a particular
logical system, or type 'all'.
view
show multicast snooping next-hops on page 2753
show multicast snooping next-hops (IGMP snooping enabled on a VPLS) on page 2753
Table 174 on page 2751 describes the output fields for the
command. Output fields are listed in the approximate order in which they appear.
Chapter 42: Operational Commands
show multicast snooping next-hops
or .
INET INET6
2751