Juniper ACX1000 Configuration Manual page 3223

Table 232: show services rpm rfc2544-benchmarking test-id Output Fields (continued)
Field Name Field Description
Consolidated information of the throughput test.
RFC2544
Throughput test
results summary
Size of the test packet in bytes.
Packet Size
Theoretical frame rate in packets-per-second.
Theoretical rate
(pps)
Number of transmitted packets.
Tx Packets
Number of received packets.
Rx Packets
The offered throughput in percentage of the chosen service (such as Layer 3 or
Offered throughput
Ethernet pseudowire).
(percentage)
Available bandwidth of the service based on the calculated throughput.
Measured
bandwidth (kbps)
Rfc2544 latency (ACX Series routers only) Details of the latency test
test information
:
Theoretical maximum bandwidth configured for the test. This value is typically
Theoretical max
set to the bandwidth of the server being tested. Valid values are 1 Kbps through
bandwidth
1,000,000 Kbps (1 Gbps). The value defined is the highest bandwidth value
used for this test.
Initial test load Percentage of the steady state load for the test.
percentage
Duration in seconds Period in seconds for which the test has been performed.
Test packet size Size of the test packet in bytes.
Iteration Number of the test iteration.
Duration (sec) Period in seconds for which the test iteration is run.
Elapsed time Amount of time that has passed, in seconds, since the start of the test.
Total count of packets-per-second (pps) transmitted during the test.
pps
Number of transmitted test packets.
Tx Packets
Number of received test packets.
Rx Packets
Displays the latency parameters.
Latency
Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
Level of Output
detail summary
detail summary
detail summary
detail summary
detail summary
detail summary
detail summary
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
3165