Juniper ACX1000 Configuration Manual page 2975

Sample Output
show protection-group ethernet-ring aps (EX Switches)
Sample Output
show protection-group ethernet-ring aps (Owner Node, Normal Operation on ACX and MX Routers)
Copyright © 2017, Juniper Networks, Inc.
Table 202: show protection-group ethernet-ring aps Output
Fields (continued)
Field Name
Request/State
Ring Protection Link Blocked
No Flush
Blocked Port Reference
e
Blocked Port Referenc
Originator
Remote Node ID
user@switch>show protection-group ethernet-ring aps
Ring Name Request/state
erp1 NR
user@host> show protection-group ethernet-ring aps
Ethernet Ring Request/state
Node ID
Erp_1 NR
00:00:00:02:00:01
Field Description
Status of the Ethernet ring RAPS messages.
—Indicates that there is no request for APS on the ring.
NR
SF —Indicates that there is a signal failure on the ring.
FS —Indicates that there are active forced-switch requests in
the ring.
—Indicates that there are active manual-switch requests
MS
in the ring.
NOTE: Both and values are valid only when G.8032v2 is
FS MS
supported.
Blocking on the ring protection link:
Indicates the value of the Do Not Flush (DNF) flag in the received
RAPS PDU. If the value is Yes, then FDB flush is not triggered
as part of processing of the received RAPS PDU.
This parameter is the reference to the blocked ring port. If the
east ring port is blocked, the Blocked Port Reference (BPR)
value is 0. If the west ring port is blocked, the BPR value is 1. If
both ring ports are blocked, this parameter can take any value.
If both east and west ports are blocked or not blocked, the value
would be 0. This field is valid only when G.8032v2 is supported.
Reference of the ring port on which traffic is blocked.
Indicates whether the node is the originator of the RAPS
messages.
Identifier (in MAC address format) of the remote node.
No Flush RPL Blocked Originator
No Yes No
RPL Blocked No Flush
Yes No
Chapter 42: Operational Commands
or .
Yes No
Remote Node ID
00:1F:12:30:B8:81
BPR Originator Remote
1 No
2917