Juniper ACX1000 Configuration Manual page 3061

Table 216: show route detail Output Fields (continued)
Field Name Field Description
Type of next hop. For a description of possible values for this field, see
Next-hop type
Number of references made to the next hop.
Next-hop reference
count
Indicates that the number of flood next-hop branches exceeded the system limit of 32 branches, and
Flood nexthop branches
only a subset of the flood next-hop branches were installed in the kernel.
exceed maximum
message
IP address of the route source.
Source
Network layer address of the directly reachable neighboring system.
Next hop
Interface used to reach the next hop. If there is more than one interface available to the next hop, the
via
name of the interface that is actually used is followed by the word
the following information:
Label-switched-path Name of the LSP used to reach the next hop.
lsp-path-name
Label operation MPLS label and operation occurring at this routing device. The operation can be
is removed from the top of the stack),
(where a label is replaced by another label).
Interface (Local only) Local interface name.
Protocol next hop Network layer address of the remote routing device that advertised the prefix. This address is used
to derive a forwarding next hop.
Index designation used to specify the mapping between protocol next hops, tags, kernel export policy,
Indirect next hop
and the forwarding next hops.
State of the route (a route can be in more than one state). See
State
Local AS AS number of the local routing device.
Age How long the route has been known.
AIGP Accumulated interior gateway protocol (AIGP) BGP attribute.
Copyright © 2017, Juniper Networks, Inc.
Weight—Value used to distinguish primary, secondary, and fast reroute backup routes. Weight
information is available when MPLS label-switched path (LSP) link protection, node-link protection,
or fast reroute is enabled, or when the standby state is enabled for secondary paths. A lower weight
value is preferred. Among routes with the same weight value, load balancing is possible.
Balance—Balance coefficient indicating how traffic of unequal cost is distributed among next hops
when a routing device is performing unequal-cost load balancing. This information is available
when you enable BGP multipath load balancing.
Selected
(where another label is added to the label stack), or
push
Table 218 on page
Chapter 42: Operational Commands
Table 217 on page 3006.
. This field can also contain
pop (where a label
swap
3008.
3003