Juniper ACX1000 Configuration Manual page 3225

Table 232: show services rpm rfc2544-benchmarking test-id Output Fields (continued)
Field Name Field Description
Mode of the test iteration: Binary or step-down.
Test iteration mode
:
The test step percentage for tests. If not specified, the default step-percent is
Test iteration step
10 percent. This parameter is ignored for all type of tests other than frame-loss
percent
tests.
Theoretical max The theoretical limit of the media for the frame size configured for the test. This
value is typically set to the bandwidth of the server being tested.
bandwidth
Test packet size: Packet size of the test frames in bytes.
Iteration Number of the test iteration.
Burst Length Number of packets in the burst.
(Packets)
Elapsed time Amount of time that has passed, in seconds, since the start of the test.
Tx Packets Number of transmitted test packets.
Rx Packets Number of received test packets.
Tx Bytes Number of transmitted bytes.
Rx Bytes Number of received bytes.
Result of the Results of the back-to-back frames test completed for a certain packet size.
iteration runs :
Best iteration : Number of the iteration with the longest burst.
Measured burst Time in seconds of the burst of the iteration with the longest burst.
(num sec)
Measured burst Number of packets during the burst of the iteration with the longest burst.
(num pkts)
RFC2544 Consolidated statistics of the back-to-back frames test.
Back-Back test
results summary:
Size of the test packets in bytes.
Packet Size
Computed burst length in terms of number of packets.
Measure Burst
length (Packets)
Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
Level of Output
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail summary
detail summary
detail summary
3167