Juniper ACX1000 Configuration Manual page 3084

ACX Series Universal Access Router Configuration Guide
Table 221: show route extensive Output Fields (continued)
Field Name Field Description
Number of routes in the routing table and total number of routes in the following states:
number routes
Route destination (for example: 10.0.0.1/24). The
route-destination
and the
(entry, announced)
the route destination is presented in another format, such as:
Protocol header information.
TSI
(Next-to-the-last-hop routing device for MPLS only) Depth of the MPLS label stack, where the
label stacking
label-popping operation is needed to remove one or more labels from the top of the stack. A pair of
routes is displayed, because the pop operation is performed only when the stack depth is two or more
labels.
[protocol, preference] Protocol from which the route was learned and the preference value for the route.
In every routing metric except for the BGP
use common comparison routines, Junos OS stores the 1's complement of the
Preference2
If the
has a higher
3026
(routes that are active).
active
(routes that are in the pending state before being declared inactive).
holddown
hidden (routes that are not used because of a routing policy).
value is the number of routes being announced for this destination. Sometimes
announced
(for example, 80001 ).
MPLS-label
interface-name (for example, ge-1/0/2).
neighbor-address:control-word-status:encapsulation type:vc-id:source
10.1.1.195:NoCtrlWord:1:1:Local/96).
—Address of the neighbor.
neighbor-address
control-word-status —Whether the use of the control word has been negotiated for this virtual
circuit: or
NoCtrlWord CtrlWord
encapsulation type —Type of encapsulation, represented by a number: (1) Frame Relay DLCI, (2)
ATM AAL5 VCC transport, (3) ATM transparent cell transport, (4) Ethernet, (5) VLAN Ethernet,
(6) HDLC, (7) PPP, (8) ATM VCC cell transport, (10) ATM VPC cell transport.
—Virtual circuit identifier.
vc-id
—Source of the advertisement:
source
indicates that a packet with an incoming label stack depth of two or more exits this router
S=0 route
with one fewer label (the label-popping operation is performed).
If there is no information, the route is a normal MPLS route, which has a stack depth of 1 (the
S=
label-popping operation is not performed).
+ —A plus sign indicates the active route, which is the route installed from the routing table into the
forwarding table.
- —A hyphen indicates the last active route.
—An asterisk indicates that the route is both the active and the last active route. An asterisk before
*
a line indicates the best subpath to the route.
to
field. For example, if the
value for Route 2 is 155, the
LocalPref
value and a lower
LocalPref
value is the number of route for this destination,
entry
.
or .
Local Remote
attribute, a lesser value is preferred. In order to
LocalPref
value for Route 1 is 100, the
LocalPref
value is -156. Route 2 is preferred because it
Preference2
value.
Preference2
Copyright © 2017, Juniper Networks, Inc.
(Layer 2 circuit only; for example,
value in the
LocalPref
value is -101.
Preference2