Show Isis Interface - Juniper ACX1000 Configuration Manual

show isis interface

List of Syntax
Syntax
Syntax (EX Series
Switches and QFX
Series)
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Syntax on page 2693
Syntax (EX Series Switches and QFX Series) on page 2693
show isis interface
<brief | detail | extensive>
<interface-name>
<logical-system (all | logical-system-name)>
show isis interface
<brief | detail | extensive>
<interface-name>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Command introduced in Junos OS Release 12.1 for the QFX Series.
Display status information about Intermediate System-to-Intermediate System
(IS-IS)-enabled interfaces.
NOTE: If the configured metric for an IS-IS level is above 63, and the
wide-metrics-only
command and the
metric value for that level. Configure the
generate metric values greater than 63 on a per IS-IS level basis.
The show isis interface
IS-IS level irrespective of whether is configured or not.
none—Display standard information about all IS-IS-enabled interfaces.
brief | detail | extensive—(Optional) Display the specified level of output.
interface-name—(Optional) Display information about the specified interface only.
logical-system (all | logical-system-name)—(Optional) Perform this operation on all
logical systems or on a particular logical system.
view
Understanding Wide IS-IS Metrics for Traffic Engineering
Example: Enabling Wide IS-IS Metrics for Traffic Engineering
statement is not configured, the
show isis interface extensive
wide-metrics-only
command displays the configured metric value for an
Chapter 42: Operational Commands
show isis interface detail
command display 63 as the
statement to
2693