Show L2-Learning Instance - Juniper ACX1000 Configuration Manual

show l2-learning instance

Syntax
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Table 164: show l2-learning instance Output Fields
Field Name Field Description
Routing Instance Name of routing instance.
Name of bridging domain.
Bridging Domain
On MX Series routers you can use the
display the Bridge Service-id information which includes the Config Service ID and the Active Service
ID.
Number associated with the routing instance or bridging domain.
Index
Name of logical system or
Logical System
Status of Layer 2 learning properties for each routing instance:
Routing instance flags
Maximum number of MAC addresses that can be learned from each interface in the routing instance
MAC limit
or bridging domain.
Copyright © 2017, Juniper Networks, Inc.
show l2-learning instance
(MX Series routers only) Command introduced in Junos OS Release 8.4.
Display Layer 2 learning properties for all the configured routing instances.
This command has no options.
view
show l2-learning instance on page 2718
Table 164 on page 2717 describes the output fields for the
command. Output fields are listed in the approximate order in which they appear.
Default
—MAC learning is disabled.
DL
—MAC accounting is enabled.
SE
AD —Packets are dropped after MAC address limit is reached.
LH —The maximum number of MAC addresses has been learned on the routing instance. The routing
instance is not able to learn any additional MAC addresses.
show l2-learning instance <extensive>
if no logical system is configured.
Chapter 42: Operational Commands
show l2-learning instance
command option to
2717