Show Ptp Global-Information - Juniper ACX1000 Configuration Manual

show ptp global-information

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
Table 209: show ptp global-information Output Fields
Field Name
PTP Global Configuration
Profile Type
Domain Number
Transport Encapsulation
Clock mode
Priority Level1
Priority Level2
Unicast Negotiation
Copyright © 2017, Juniper Networks, Inc.
show ptp global-information
Command introduced in Junos OS Release 12.2.
Command introduced in Junos OS Release 12.3X54–D20 for ACX500 Series routers.
Show Precision Time Protocol (PTP)-related global information.
This command has no options.
view
IEEE 1588v2 PTP Boundary Clock Overview on page 234
IEEE 1588v2 Precision Timing Protocol (PTP) on ACX Series Universal Access Routers
on page 237
show ptp global-information on page 2941
Table 209 on page 2939 lists the output fields for the
Output fields are listed in the approximate order in which they appear.
Field Description
Configured PTP, master, and slave parameters.
Profile Type
PTP domain with values from 0 through 127. The default value is 0. Only one PTP domain is supported
at any given point in time.
Name of the encapsulation type: Ipv4.
Clock mode is either boundary or ordinary.
Priority value of the clock: 0 through 255. The default is 128. The lower value takes precedence.
Priority value of the clock: 0 through 255. The default is 128. This value is used to differentiate and
prioritize the master clocks when the
The lower value takes precedence.
Method by which the announce, synchronization, and delay-response packet rates are negotiated
between the master and the slave or client before a PTP session is established. Unicast negotiation
is enabled or disabled.
Chapter 42: Operational Commands
show ptp global-information
is the same for different master clocks in a network.
priority1-value
command.
2939