Show Lldp Local-Information - Juniper ACX1000 Configuration Manual

show lldp local-information

Syntax
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Copyright © 2017, Juniper Networks, Inc.
show lldp local-information
Command introduced in Junos OS Release 9.6.
Display local Link Layer Discovery Protocol (LLDP) information.
This command has no options.
view
show lldp local-information(Management Information Address Subtype is
IPv4) on page 2735
show lldp local-information(Management Information Address Subtype is
IPv6) on page 2735
Table 169 on page 2733 describes the output fields for the
command. Output fields are listed in the approximate order in which they appear.
Table 169: show lldp local-information Output Fields
Field Name Field Description
LLDP Local Information that follows pertains to the local system.
Information details
List of chassis identifiers for local information.
Chassis ID
System name Local system name reported by LLDP.
System descr Local system description reported by LLDP.
System Capabilities Capabilities (such as
on the interface.
Management Listed by
Information as 192.168.168.229
Interface Name List of local interfaces.
For information about interface names, see Interface Naming Overview. For
information about interface names for TX Matrix routers, see TX Matrix Router
Chassis and Interface Names. For information about FPC numbering on TX Matrix
routers, see Routing Matrix with a TX Matrix Router FPC Numbering.
Name of the
Parent Interface
List of local interface identifiers.
Interface ID
Bridge or Router ) that are
Interface Name , Address Subtype
, 1fd::1a10 ), Interface Number
interface to which the interface belongs
ae
Chapter 42: Operational Commands
show lldp local-information
Supported or Enabled by system
(such as ipv4 , ipv6 ), Address
, and Interface Numbering Subtype
(such
.
2733