Juniper ACX1000 Configuration Manual page 3183

Table 229: Communities Output Field Values
Value
area-number
bandwidth: local AS
number:link-bandwidth-number
domain-id
domain-id-vendor
link-bandwidth-number
local AS number
Copyright © 2017, Juniper Networks, Inc.
Table 228: State Output Field Values (continued)
Value
Pending
Release
RIB preference
Route Distinguisher
Route Metric or MED comparison
Route Preference
Router ID
Secondary
Unusable path
Update source
Table 219 on page 3010 describes the possible values for the Communities output field.
Description
4 bytes, encoding a 32-bit area number. For AS-external routes, the value is
identifies the route as internal to the OSPF domain, and as within the identified area. Area
numbers are relative to a particular OSPF domain.
Link-bandwidth community value used for unequal-cost load balancing. When BGP has
several candidate paths available for multipath purposes, it does not perform unequal-cost
load balancing according to the link-bandwidth community unless all candidate paths have
this attribute.
Unique configurable number that identifies the OSPF domain.
Unique configurable number that further identifies the OSPF domain.
Link-bandwidth number: from
Local AS number: from
1
Description
Route pending because of a hold-down configured on another
route.
Route scheduled for release.
Route from a higher-numbered routing table is available.
64-bit prefix added to IP subnets to make them unique.
Route with a lower metric or MED is available.
Route with lower preference value is available.
Path through a neighbor with lower ID is available.
Route not a primary route.
Path is not usable because of one of the following conditions:
The route is damped.
The route is rejected by an import policy.
The route is unresolved.
Last tiebreaker is the lowest IP address value.
through
0 4,294,967,295
through .
65,535
Chapter 42: Operational Commands
0 . A nonzero value
(bytes per second).
3125