Juniper ACX1000 Configuration Manual page 2963

Table 199: show ppp interface Output Fields (continued)
Field Name Field Description
OSINLCP State OSI Network Layer Control Protocol (OSINLCP) protocol state information (all platforms
except M120 and M320 routers):
State:
Ack-rcvd
Ack-sent
has not yet been received.
Closed
Opened
Req-sent
Last started
Last completed
TAGCP information.
TAGCP
State
Ack-rcvd
Ack-sent
Configure-Ack has not yet been received.
Closed
Opened
Req-sent
State
Ack-rcvd
Ack-sent
Configure-Ack has not yet been received.
Closed
Closing
received.
Opened
sent and received.
Req-sent
has been sent but a Configure-Ack has not yet been received.
Starting
(Down).
Stopped
or after sending a Terminate-Ack.
Stopping
received.
Last started
Last completed
Copyright © 2017, Juniper Networks, Inc.
—Configure-Request has been sent and Configure-Ack has been received.
—Configure-Request and Configure-Ack have both been sent, but Configure-Ack
—Link is not available for traffic.
—Link is administratively available for traffic.
—Attempt has been made to configure the connection.
—OSINLCP state start time.
—OSINCLP state completion time.
—(All platforms except M120 and M320 routers) One of the following values:
—A Configure-Request has been sent and a Configure-Ack has been received.
—A Configure-Request and a Configure-Ack have both been sent, but a
—Link is not available for traffic.
—Link is administratively available for traffic.
—An attempt has been made to configure the connection.
—(M120 and M320 routers) One of the following values:
—A Configure-Request has been sent and a Configure-Ack has been received.
—A Configure-Request and a Configure-Ack have both been sent, but a
—Link is available (up), but no Open has occurred.
—A Terminate-Request has been sent but a Terminate-Ack has not yet been
—Link is administratively available for traffic. A Configure-Ack has been both
—An attempt has been made to configure the connection. A Configure-Request
—An administrative Open has been initiated, but the lower layer is still unavailable
—The system is waiting for a Down event after the This-Layer-Finished action,
—A Terminate-Request has been sent but a Terminate-Ack has not yet been
—TAGCP state start time.
—TAGCP state authentication completion time.
Chapter 42: Operational Commands
Level of
Output
extensive
extensive
none
2905