Juniper ACX1000 Configuration Manual page 2897

show ospf interface area area-id
show ospf interface extensive
(When Flooding Reduction Is Enabled)
show ospf interface extensive
(When LDP Synchronization Is Configured)
Copyright © 2017, Juniper Networks, Inc.
Type: P2P, Address: 0.0.0.0, Mask: 0.0.0.0, MTU: 4470, Cost: 1
Adj count: 1, Secondary
Hello: 10, Dead: 40, ReXmit: 5, Not Stub
Auth type: None
Topology default (ID 0) -> Cost: 1
so-1/0/0.0 PtToPt
Type: P2P, Address: 0.0.0.0, Mask: 0.0.0.0, MTU: 4470, Cost: 1
Adj count: 1, Secondary
Hello: 10, Dead: 40, ReXmit: 5, Not Stub
Auth type: None
Topology default (ID 0) -> Cost: 1
user@host> show ospf interface area 1.1.1.1
Interface State
so-0/0/0.0 PtToPt
so-1/0/0.0 PtToPt
user@host> show ospf interface extensive
Interface State
fe-0/0/0.0 PtToPt
Type: P2P, Address: 10.10.10.1, Mask: 255.255.255.0, MTU: 1500, Cost: 1
Adj count: 0
Secondary, Flood Reduction
Hello: 10, Dead: 40, ReXmit: 5, Not Stub
Auth type: None
Topology default (ID 0) -> Cost: 1
user@host> show ospf interface extensive
Interface State
Nbrs
so-1/0/3.0 Down
0
Type: P2P, Address: 0.0.0.0, Mask: 0.0.0.0, MTU: 4470, Cost: 65535
Adj count: 0
Hello: 10, Dead: 40, ReXmit: 5, Not Stub
Auth type: None
LDP sync state: in holddown, for: 00:00:08, reason: LDP down during config
config holdtime: 10 seconds, remaining: 1
2.2.2.2 0.0.0.0
Area DR ID
1.1.1.1 0.0.0.0
1.1.1.1 0.0.0.0
Area DR ID
0.0.0.0 0.0.0.0
Area DR ID
0.0.0.0 0.0.0.0
Chapter 42: Operational Commands
0.0.0.0
BDR ID Nbrs
0.0.0.0
0.0.0.0
BDR ID Nbrs
0.0.0.0
BDR ID
0.0.0.0
2839
1
1
1
0