Juniper ACX1000 Configuration Manual page 3179

Table 226: show route table Output Fields (continued)
Field Name Field Description
weight Value used to distinguish MoFRR primary and backup routes. A lower weight value is preferred. Among
routes with the same weight value, load balancing is possible.
VC Label MPLS label assigned to the Layer 2 circuit virtual connection.
MTU Maximum transmission unit (MTU) of the Layer 2 circuit.
VLAN ID VLAN identifier of the Layer 2 circuit.
Prefixes bound to route Forwarding equivalent class (FEC) bound to this route. Applicable only to routes installed by LDP.
Communities Community path attribute for the route. See
Layer2-info: encaps Layer 2 encapsulation (for example, VPLS).
control flags Control flags:
mtu Maximum transmission unit (MTU) information.
Label-Base, range First label in a block of labels and label block size. A remote PE routing device uses this first label
when sending traffic toward the advertising PE routing device.
status vector Layer 2 VPN and VPLS network layer reachability information (NLRI).
Accepted Multipath Current active path when BGP multipath is configured.
Accepted The LongLivedStale flag indicates that the route was marked LLGR-stale by this router, as part of the
LongLivedStale operation of LLGR receiver mode. Either this flag or the LongLivedStaleImport flag might be displayed
for a route. Neither of these flags is displayed at the same time as the Stale (ordinary GR stale) flag.
Accepted The LongLivedStaleImport flag indicates that the route was marked LLGR-stale when it was received
LongLivedStaleImport from a peer, or by import policy. Either this flag or the LongLivedStale flag might be displayed for a
route. Neither of these flags is displayed at the same time as the Stale (ordinary GR stale) flag.
Accept all received BGP long-lived graceful restart (LLGR) and LLGR stale routes learned from
configured neighbors and import into the inet.0 routing table
ImportAccepted Accept all received BGP long-lived graceful restart (LLGR) and LLGR stale routes learned from
LongLivedStaleImport configured neighbors and imported into the inet.0 routing table
The LongLivedStaleImport flag indicates that the route was marked LLGR-stale when it was received
from a peer, or by import policy.
Accepted Path currently contributing to BGP multipath.
MultipathContrib
Localpref Local preference value included in the route.
Router ID BGP router ID as advertised by the neighbor in the open message.
Copyright © 2017, Juniper Networks, Inc.
or .
none Site Down
Chapter 42: Operational Commands
Table 219 on page 3010 for all possible values for this field.
3121