Test Services Rpm Rfc2544-Benchmarking Test - Juniper ACX1000 Configuration Manual

test services rpm rfc2544-benchmarking test

List of Syntax
Syntax (ACX Series)
Syntax (MX104
Router)
Release Information
Description
Options
Copyright © 2017, Juniper Networks, Inc.
Syntax (ACX Series) on page 3211
Syntax (MX104 Router) on page 3211
test services rpm rfc2544-benchmarking test
<clear-counters>
<routing-instance routing-instance-name>
<test-name>
<test-id>
<start>
<stop>
test services rpm rfc2544-benchmarking test
<test-name>
<test-id>
<start>>
<stop>
Command introduced in Junos OS Release 12.3X52 for ACX Series routers.
Command introduced in Junos OS Release 13.3R1 for MX104 3D Universal Edge routers.
Start or stop an RFC 2544-based benchmarking test. You can start or stop all of the test
names that are defined on a router, or start or stop a specific test name. You can also
stop a test based on its test identifier. You can also clear the statistical counters
associated with the test. When you trigger an RFC 2544-based benchmarking test, it
passes through a series of states. These states are displayed in the Test state field in the
brief or displayed output information of the
command.
NOTE: The RFC 2544 test is stopped at the initiator automatically after the
test successfully completes all of the test steps. You need not explicitly enter
the
test services rpm rfc2544-benchmarking test <test-name | test-id> stop
command. However, at the reflector, you must explicitly enter this command
to stop the test after the test is completed at the initiator.
When a Layer 2 circuit pseudowire is not up, you cannot start the RFC 2544-based
benchmarking test in reflection test mode by entering the
rfc2544-benchmarking test test-name start
test mode, a message is displayed explaining the reason for the failure to commence the
test.
start —Start the RFC 2544-based benchmarking test
—Terminate the RFC 2544-based benchmarking test
stop
Chapter 42: Operational Commands
show services rpm rfc2544-benchmarking
test services rpm
command. If you attempt to start the reflection
3211