Show (Ospf | Ospf3) Neighbor - Juniper ACX1000 Configuration Manual

show (ospf | ospf3) neighbor

List of Syntax
Syntax
Syntax (EX Series
Switches and QFX
Series)
Release Information
Description
Options
Copyright © 2017, Juniper Networks, Inc.
Syntax on page 2845
Syntax (EX Series Switches and QFX Series) on page 2845
show (ospf | ospf3) neighbor
<brief | detail | extensive>
<area area-id>
<instance (all | instance-name)>
<interface interface-name>
<logical-system (all | logical-system-name)>
<neighbor>
<realm (ipv4-multicast | ipv4-unicast | ipv6-multicast)>
show (ospf | ospf3) neighbor
<brief | detail | extensive>
<area area-id>
<instance (all | instance-name)>
<interface interface-name>
<neighbor>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
option introduced in Junos OS Release 9.1.
instance all
instance all option introduced in Junos OS Release 9.1 for EX Series switches.
, , and options introduced in Junos OS Release 9.2.
area interface realm
and options introduced in Junos OS Release 9.2 for EX Series switches.
area interface
Command introduced in Junos OS Release 11.3 for the QFX Series.
Command introduced in Junos OS Release 14.1X53-D20 for the OCX Series.
Display information about OSPF neighbors.
CPU utilization might increase while the device learns its OSPF neighbors. We recommend
that you use the
show (ospf | ospf3) neighbor
establishes OSPF neighbor adjacencies. Depending on the size of your network, this might
take several minutes. If you receive a "timeout communicating with routing daemon"
error when using the
show (ospf | ospf3) neighbor
attempting to use the command again. This is not a critical system error, but you might
experience a delay in using the CLI.
none—Display standard information about all OSPF neighbors for all routing instances.
brief | detail | extensive—(Optional) Display the specified level of output.
area area-id—(Optional) Display information about the OSPF neighbors for the specified
area.
instance (all | instance-name)—(Optional) Display all OSPF interfaces for all routing
instances or under the named routing instance.
Chapter 42: Operational Commands
command after the device learns and
command, wait several minutes before
2845