show route protocol
List of Syntax
Syntax
Syntax (EX Series
Switches)
Release Information
Description
Options
Copyright © 2017, Juniper Networks, Inc.
Syntax on page 3093
Syntax (EX Series Switches) on page 3093
show route protocol protocol
<brief | detail | extensive | terse>
<logical-system (all | logical-system-name)>
show route protocol protocol
<brief | detail | extensive | terse>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
and
options introduced in Junos OS Release 9.2.
ospf2
ospf3
ospf2
and
ospf3
options introduced in Junos OS Release 9.2 for EX Series switches.
option introduced in Junos OS Release 10.0.
flow
option introduced in Junos OS Release 10.0 for EX Series switches.
flow
Display the route entries in the routing table that were learned from a particular protocol.
brief | detail | extensive | terse—(Optional) Display the specified level of output. If you
do not specify a level of output, the system defaults to
logical-system (all | logical-system-name)—(Optional) Perform this operation on all
logical systems or on a particular logical system.
protocol—Protocol from which the route was learned:
—Access route for use by DHCP application
access
access-internal
—Access-internal route for use by DHCP application
—Locally generated aggregate route
aggregate
arp
—Route learned through the Address Resolution Protocol
—Asynchronous Transfer Mode virtual private network
atmvpn
bgp
—Border Gateway Protocol
—Circuit cross-connect
ccc
—Directly connected route
direct
—Distance Vector Multicast Routing Protocol
dvmrp
—End System-to-Intermediate System
esis
—Locally defined flow-specification route
flow
—Precomputed protection route or backup route used when a link goes down
frr
isis
—Intermediate System-to-Intermediate System
Chapter 42: Operational Commands
.
brief
3093