Juniper ACX1000 Configuration Manual page 3166

ACX Series Universal Access Router Configuration Guide
Table 225: show route receive-protocol Output Fields (continued)
Field Name Field Description
Next hop to the destination. An angle bracket (>) indicates that the route is the
Next hop
selected route.
Localpref or Lclpref Local preference value included in the route.
AS path Autonomous system (AS) path through which the route was learned. The letters
at the end of the AS path indicate the path origin, providing an indication of the
state of the route at the point at which the AS path originated:
—IGP.
I
E —EGP.
? —Incomplete; typically, the AS path was aggregated.
When AS path numbers are included in the route, the format is as follows:
[ ] —Brackets enclose the number that precedes the AS path. This number
represents the number of ASs present in the AS path, when calculated as
defined in RFC 4271. This value is used the AS-path merge process, as defined
in RFC 4893.
[ ] —If more than one AS number is configured on the router, or if AS path
prepending is configured, brackets enclose the local AS number associated
with the AS path.
{ } —Braces enclose AS sets, which are groups of AS numbers in which the
order does not matter. A set commonly results from route aggregation. The
numbers in each AS set are displayed in ascending order.
—Parentheses enclose a confederation.
( )
( [ ] )
NOTE:
unrecognized attribute and associated hexadecimal value if BGP receives
attribute 128 (attribute set) and you have not configured an independent domain
in any routing instance.
Stack of labels carried in the BGP route update.
Route Labels
(For route reflected output only) Cluster ID sent by the route reflector.
Cluster list
(For route reflected output only) Address of routing device that originally sent
Originator ID
the route to the route reflector.
Communities Community path attribute for the route. See the Output Field table in the
route detail
Accumulated interior gateway protocol (AIGP) BGP attribute.
AIGP
Number, local preference, and path of the AS that originated the route. These
Attrset AS
values are stored in the
Layer2-info: encaps Layer 2 encapsulation (for example, VPLS).
control flags Control flags:
3108
—Parentheses and brackets enclose a confederation set.
In Junos OS Release 10.3 and later, the AS path field displays an
command for all possible values for this field.
Attrset attribute at the originating routing device.
none or Site Down .
Level of Output
All levels
All levels
All levels
detail extensive
detail extensive
detail extensive
show detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
Copyright © 2017, Juniper Networks, Inc.