Juniper ACX1000 Configuration Manual page 3054

ACX Series Universal Access Router Configuration Guide
Table 215: show route damping Output Fields
Field Name Field Description
Name of the routing table—for example,
routing-table-name
Number of destinations for which there are routes in the routing table.
destinations
Number of routes in the routing table and total number of routes in the following
number routes
states:
active
holddown
hidden
Destination prefix. The
destination-prefix
and the
(entry, announced)
destination.
Protocol from which the route was learned and the preference value for the
[protocol,
route.
preference]
+ —A plus sign indicates the active route, which is the route installed from the
routing table into the forwarding table.
—A hyphen indicates the last active route.
-
—An asterisk indicates that the route is both the active and the last active
*
route. An asterisk before a
In every routing metric except for the BGP
preferred. In order to use common comparison routines, Junos OS stores the 1's
complement of the
LocalPref value for Route 1 is 100, the Preference2 value is -101. If the
value for Route 2 is 155, the
because it has a higher
Number of references made to the next hop.
Next-hop reference
count
Source IP address of the route source.
Network layer address of the directly reachable neighboring system.
Next hop
Interface used to reach the next hop. If there is more than one interface available
via
to the next hop, the interface that is actually used is followed by the word
Selected
Network layer address of the remote routing device that advertised the prefix.
Protocol next hop
This address is used to derive a forwarding next hop.
Indirect next hop Index designation used to specify the mapping between protocol next hops,
tags, kernel export policy, and the forwarding next hops.
Flags for this route. For a description of possible values for this field, see the
State
output field table for the
2996
(routes that are in a pending state before being declared inactive)
(the routes are not used because of a routing policy)
value is the number of routes for this destination,
entry
value is the number of routes being announced for this
announced
line indicates the best subpath to the route.
to
value in the
LocalPref
Preference2
value and a lower
LocalPref
.
show route detail
.
inet.0
attribute, a lesser value is
LocalPref
field. For example, if the
Preference2
LocalPref
value is -156. Route 2 is preferred
value.
Preference2
command.
Copyright © 2017, Juniper Networks, Inc.
Level of Output
All levels
All levels
All levels
detail extensive
All levels
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive