Juniper ACX1000 Configuration Manual page 3086

ACX Series Universal Access Router Configuration Guide
Table 221: show route extensive Output Fields (continued)
Field Name Field Description
MPLS label and operation occurring at this routing device. The operation can be
label-operation
is removed from the top of the stack),
(where a label is replaced by another label).
When present, a list of nodes that are used to resolve the path to the next-hop destination, in the
Indirect next hops
order that they are resolved.
When BGP PIC Edge is enabled, the output lines that contain
hops that the software can use to repair paths where a link failure occurs. The next-hop weight has
one of the following values:
State of the route (a route can be in more than one state). See the Output Field table in the
State
route detail
The BFD session ID number that represents the protection using MPLS fast reroute (FRR) and loop-free
Session ID
alternate (LFA).
Weight for the backup path. If the weight of an indirect next hop is larger than zero, the weight value
Weight
is shown.
For sample output, see
3028
0x1 indicates active next hops.
0x4000 indicates passive next hops.
command.
show route table
(where another label is added to the label stack), or
push
Indirect next hop: weight
.
Copyright © 2017, Juniper Networks, Inc.
(where a label
pop
swap
follow next
show