Juniper ACX1000 Configuration Manual page 2839

Table 179: show oam ethernet connectivity-fault-management delay-statistics and
mep-statistics Output Fields (continued)
Output Field Name
Average one-way delay
Average one-way delay variation
Best-case one-way delay
Worst-case one-way delay
Average two-way delay
Average two-way delay variation
Best-case two-way delay
Worst-case two-way delay
SLM packets sent
SLM packets received
SLR packets sent
SLR packets received
Local TXFC1 value
Local RXFC1 value
Last Received SLR frame TXFCf(tc)
Last Received SLR frame TXFCb(t
Frame loss (near-end)
Frame loss (far-end)
Copyright © 2017, Juniper Networks, Inc.
Field Description
Average one-way frame delay for the statistics displayed.
Average one-way "frame jitter" for the statistics displayed.
Lowest one-way frame delay for the statistics displayed.
Highest one-way frame delay for the statistics displayed.
Average two-way frame delay for the statistics displayed.
Average two-way "frame jitter" for the statistics displayed.
Lowest two-way frame delay for the statistics displayed.
Highest two-way frame delay calculated in this session.
Total number of synthetic loss message (SLM) PDU frames sent from the source
MEP to the remote MEP during this ETH-SLM session.
Total number of synthetic loss message (SLM) PDU frames that the remote
MEP received from the source MEP during this ETH-SLM session.
Total number of synthetic loss reply (SLR) PDU frames that the remote MEP
sent to the source MEP during this measurement session.
Total number of synthetic loss reply (SLR) PDU frames that the source MEP
received from the remote MEP during this measurement session.
Number of synthetic frames transmitted to the peer MEP for a test ID. A test ID
is used to distinguish each synthetic loss measurement because multiple
measurements can be simultaneously activated also on a given CoS and MEP
pair. It must be unique at least within the context of any SLM for the MEG and
initiating MEP.
Number of synthetic frames received from the peer MEP for a test ID. The MEP
generates a unique Test ID for the session, adds the source MEP ID, and initializes
the local counters for the session before SLM initiation. For each SLM PDU
transmitted for the session (test ID), the local counter TXFC1 is sent in the packet.
Value of the local counter TxFCl at the time of SLM frame transmission.
Value of the local counter RxFCl at the time of SLR frame transmission.
Count of frame loss associated with ingress data frames.
Count of frame loss associated with egress data frames.
Chapter 42: Operational Commands
2781