Juniper ACX1000 Configuration Manual page 3270

ACX Series Universal Access Router Configuration Guide
Additional Information
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
Sample Output
test services rpm rfc2544-benchmarking test start
3212
—(ACX Series routers only) Clear the statistics associated with the
clear-counters
benchmarking test that was run.
—(ACX Series routers only) (Optional) Name of the routing instance for
routing-instance
the test.
test-name —(Optional) Name of the benchmarking test that must be started or stopped.
—(Optional) Unique identifier of the test that must be stopped. You can stop a
test-id
test based on the test identifier. You can use the
services rpm rfc2544-benchmarking stop
The test session is supported in out-of-service mode for the underlying service. You must
not transmit any traffic to the UNI port, configured as a generator or a reflector, that is
being tested during the duration of the test.
view
Configuring an RFC 2544-Based Benchmarking Test
RFC2544-Based Benchmarking Tests Overview
rfc2544-benchmarking on page 1698
test services rpm rfc2544-benchmarking test start on page 3212
To display the results of the benchmarking test, use the
rfc2544-benchmarking test start
user@host> test services rpm rfc2544-benchmarking test test1 start
Test "test1" id 56 started
The response specifies that a test has been started with test id 56. The test ID can be
further used in commands to view test output.
show
test-id
command.
show services rpm
command.
Copyright © 2017, Juniper Networks, Inc.
option with only the
test