Juniper ACX1000 Configuration Manual page 3215

Related
Documentation
List of Sample Output
Output Fields
Table 231: show services rpm rfc2544-benchmarking Output Fields
Field Name Field Description
Details of the performed RFC 2544 benchmarking test.
Test information
Unique identifier configured for the test.
Test id
Name configured for the test.
Test name
The type of statistical detail that is collected for the test, based on the configured
Test type
test type. Throughput-related, latency, frame-loss, or back-to-back
frames-related information is displayed for ACX Series routers. Reflected
packets-related information is displayed for MX104 Series routers.
Mode configured for the test on the router. Test modes are:
Test mode
Initiate-and-Terminate: Test frames are initiated from one end and terminated
at the same end. This mode requires a reflector to be configured at the peer
end to enable the test frames to be returned to the source. This mode is
supported only on ACX Series routers.
Reflect: Test frames that originate from one end are reflected at the other
end on the selected service, such as IPv4 or Ethernet.
Size of the test packets in bytes. This field is valid only when the test mode is
Test packet size
Initiate-and-Terminate.
Test state State of the test that is in progress or active when the output is displayed.
Status Indicates whether the test is currently in progress or has been terminated. This
field is displayed for tests that are in progress or were aborted by entering the
test services rpm rfc2544-benchmarking test <test-name | test-id> stop
Copyright © 2017, Juniper Networks, Inc.
Configuring an RFC 2544-Based Benchmarking Test
RFC2544-Based Benchmarking Tests Overview
rfc2544-benchmarking on page 1698
show services rpm rfc2544-benchmarking summary on page 3158
show services rpm rfc2544-benchmarking aborted-tests (ACX Series
Router) on page 3158
show services rpm rfc2544-benchmarking completed-tests (ACX Series
Router) on page 3159
show services rpm rfc2544-benchmarking active-tests (ACX Series Router) on page 3159
show services rpm rfc2544-benchmarking aborted-tests (MX104 Router) on page 3159
show services rpm rfc2544-benchmarking completed-tests (MX104 Router) on page 3160
show services rpm rfc2544-benchmarking active-tests (MX104 Router) on page 3160
Table 231 on page 3157 lists the output fields for the
command. Output fields are listed in the approximate order in
rfc2544-benchmarking
which they appear.
Chapter 42: Operational Commands
show services rpm
command.
3157