Juniper ACX1000 Configuration Manual page 3066

ACX Series Universal Access Router Configuration Guide
3008
Table 217: Next-hop Types Output Field Values (continued)
Next-Hop Type
Unicast (ucst)
Unilist (ulst)
Table 218 on page 3008 describes all possible values for the State output field. A route can
be in more than one state (for example,
Table 218: State Output Field Values
Value
Accounting
Active
Always Compare MED
AS path
Cisco Non-deterministic MED
selection
Clone
Cluster list length
Delete
Ex
Ext
FlashAll
Hidden
IfCheck
IGP metric
Inactive reason
Initial
Description
Unicast.
List of unicast next hops. A packet sent to this next hop
goes to any next hop in the list.
<Active NoReadvrt Int Ext>
Description
Route needs accounting.
Route is active.
Path with a lower multiple exit discriminator (MED) is
available.
Shorter AS path is available.
Cisco nondeterministic MED is enabled, and a path with a
lower MED is available.
Route is a clone.
Length of cluster list sent by the route reflector.
Route has been deleted.
Exterior route.
BGP route received from an external BGP neighbor.
Forces all protocols to be notified of a change to any route,
active or inactive, for a prefix. When not set, protocols are
informed of a prefix only when the active route changes.
Route not used because of routing policy.
Route needs forwarding RPF check.
Path through next hop with lower IGP metric is available.
Flags for this route, which was not selected as best for a
particular destination.
Route being added.
Copyright © 2017, Juniper Networks, Inc.
).