Juniper ACX1000 Configuration Manual page 3108

ACX Series Universal Access Router Configuration Guide
Table 223: show route forwarding-table Output Fields (continued)
Field Name Field Description
Route Type (Type) How the route was placed into the forwarding table. When the
is used, the route type might be abbreviated (as shown in parentheses):
cloned
destination
destination down
unreachable.
interface cloned
route down
ignore
interface
permanent
initialized.
user
configuration.
Route Reference Number of routes to reference.
(RtRef)
Flags Route type flags:
none
accounting
cached
incoming-iface interface-number
prefix load balance
rt nh decoupled
destination.
sent to PFE
static
Next hop IP address of the next hop to the destination.
3050
( )—(TCP or multicast only) Cloned route.
clon
( )—Remote addresses directly reachable through an interface.
dest
( iddn )—Destination route for which the interface is
( ifcl )—Cloned route for which the interface is unreachable.
( )—Interface route for which the interface is unreachable.
ifdn
( )—Ignore this route.
ignr
( )—Installed as a result of configuring an interface.
intf
( )—Routes installed by the kernel when the routing table is
perm
—Routes installed by the routing protocol process or as a result of the
—No flags are enabled.
—Route has accounting enabled.
—Cache route.
—Check against incoming interface.
—Load balancing is enabled for this prefix.
—Route has been decoupled from the next hop to the
—Route has been sent to the Packet Forwarding Engine.
—Static route.
Level of Output
keyword All levels
detail
detail extensive
extensive
detail extensive
Copyright © 2017, Juniper Networks, Inc.