Juniper ACX1000 Configuration Manual page 2964

ACX Series Universal Access Router Configuration Guide
Sample Output
show ppp interface
show ppp interface extensive
user@host> show ppp interface si-0/0/3.0 extensive
Session si-0/0/3.0, Type: PPP, Phase: Network
Keepalive settings: Interval 30 seconds, Up-count 1, Down-count 3
RE Keepalive statistics:
LCP echo req Tx
LCP echo req Rx
LCP echo rep Tx
LCP echo rep Rx
LCP echo req timout
LCP Rx echo req Magic Num Failures :
LCP Rx echo rep Magic Num Failures :
LCP
State: Opened
Last started: 2007-01-29 10:43:50 PST
Last completed: 2007-01-29 10:43:50 PST
Negotiated options:
Authentication protocol: PAP, Magic number: 2341124815, MRU: 4470
Authentication: PAP
State: Success
Last started: 2007-01-29 10:43:50 PST
Last completed: 2007-01-29 10:43:50 PST
IPCP
State: Opened
Last started: 2007-01-29 10:43:50 PST
Last completed: 2007-01-29 10:43:50 PST
Negotiated options:
Local address: 203.0.113.21, Remote address: 203.0.113.22
Negotiation mode: Active
IPV6CP
State: Opened
Last started: 2007-01-29 10:43:50 PST
Last completed: 2007-01-29 10:43:50 PST
Negotiated options:
Local interface identifier: 2a0:a522:64:d319, Remote interface identifier: 0:0:0:c
Negotiation mode: Passive
show ppp interface terse
2906
user@host> show ppp interface si-1/3/0.0
Session si-1/3/0.0, Type: PPP, Phase: Authenticate
Session flags: Monitored
LCP State: Opened
AUTHENTICATION: CHAP State: Chap-resp-sent, Chap-ans-sent
IPCP State: Closed, OSINLCP State: Closed
: 657 (last sent 00:50:10 ago)
: 0 (last seen: never)
: 0
: 657
: 0
0
0
user@host> show ppp interface si-1/3/0 terse
Session name Session type
si-1/3/0.0 PPP
Session phase Session flags
Authenticate Monitored
Copyright © 2017, Juniper Networks, Inc.