Juniper ACX1000 Configuration Manual page 2893

Required Privilege
Level
List of Sample Output
Output Fields
Table 186: show (ospf | ospf3) interface Output Fields
Field Name Field Description
Interface Name of the interface running OSPF version 2 or OSPF version 3.
State State of the interface:
Area Number of the area that the interface is in.
DR ID Address of the area's designated router.
Backup designated router for a particular subnet.
BDR ID
Number of neighbors on this interface.
Nbrs
Type of interface:
Type
IP address of the neighbor.
Address
Netmask of the neighbor.
Mask
(OSPFv3) IPv6 prefix length, in bits.
Prefix-length
(OSPFv3) OSPF version 3 interface index.
OSPF3-Intf-Index
Interface maximum transmission unit (MTU).
MTU
Interface cost (metric).
Cost
Address of the designated router.
DR addr
Address of the backup designated router.
BDR addr
Number of adjacent neighbors.
Adj count
Copyright © 2017, Juniper Networks, Inc.
view
show ospf interface brief on page 2837
show ospf interface detail on page 2837
show ospf3 interface detail on page 2837
show ospf interface detail(When Multiarea Adjacency Is Configured) on page 2837
show ospf interface area area-id on page 2839
show ospf interface extensive (When Flooding Reduction Is Enabled) on page 2839
show ospf interface extensive (When LDP Synchronization Is Configured) on page 2839
Table 186 on page 2835 lists the output fields for the
Output fields are listed in the approximate order in which they appear.
BDR , Down , DR
, ,
LAN NBMA P2MP
show (ospf | ospf3) interface
, DRother , Loop , PtToPt , or Waiting
, , or .
P2P Virtual
Chapter 42: Operational Commands
command.
Level of Output
All levels
. All levels
All levels
All levels
All levels
All levels
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
2835