Juniper ACX1000 Configuration Manual page 2829

Table 178: show oam ethernet connectivity-fault-management interfaces Output
Fields (continued)
Field Name Field Description
Alarm Indication Indicates whether the AIS is triggered or is cleared.
Signal
Number of CCMs transmitted.
CCMs sent
Number of CCMs received out of sequence.
CCMs received out
of sequence
Number of loopback request messages (LBMs) sent.
LBMs sent
Number of loopback response messages (LBRs) received that were valid
Valid in-order LBRs
messages and in sequence.
received
Number of LBRs received that were valid messages and not in sequence.
Valid out-of-order
LBRs received
Number of LBRs received that were corrupted.
LBRs received with
corrupted data
Number of LBRs transmitted.
LBRs sent
Linktrace messages (LTMs) transmitted.
LTMs sent
Linktrace messages received.
LTMs received
Linktrace responses (LTRs) transmitted.
LTRs sent
Linktrace responses received.
LTRs received
Sequence number of next LTM request to be transmitted.
Sequence number
of next LTM request
If the interface is attached to an initiator MEP for a one-way ETH-DM session:
1DMs sent
Number of one-way delay measurement (1DM) PDU frames sent to the peer
MEP in this session.
For all other cases, this field displays
Valid 1DMs received If the interface is attached to a receiver MEP for a one-way ETH-DM session:
Number of valid 1DM frames received.
For all other cases, this field displays
Invalid 1DMs If the interface is attached to a receiver MEP for a one-way ETH-DM session:
received Number of invalid 1DM frames received.
For all other cases, this field displays
Copyright © 2017, Juniper Networks, Inc.
.
0
0 .
0 .
Chapter 42: Operational Commands
Level of Output
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
detail extensive
2771